Instructions
1. Before installing the ATack Fiberglass Tape, it would be best to measure the strip sizes and the exact areas which you need to install the tape. Make sure that the surfaces are dry and the cement boards are clean and free of moisture before installing the tape.
2. Pre-cut the tape based on your desired strip lengths and sizes. You can use a sharp pair of scissors or a cutter to cut the water proofing tape. Important: We care about your safety. Please be careful in handling sharp objects. Make sure that the blade's sharp edge and direction of operation is facing aways from you while cutting.
3. Apply a liquid waterproofing membrane to the surface and then put the waterproofing membrane Tape. You can use any liquid membrane as the ATack Waterproofing membrane Fabric Sheet is built compatible with all leading waterproofing membrane liquids. Make sure to cover all seams, joints, and areas on your wall with the membrane and the tape.
4. Finally, Coat the tape with an additional layer of the waterproofing liquid, forming a liquid-tape-liquid trilayer.
5. Apply more tape strips as needed.
6. Let the tape and membrane cure and dry overnight.
How To: Neat and Professional Setup
To achieve a cleaner and professional-looking application, follow the following steps:
1. Cut the tape strips precisely to avoid overlapping and uneven surfaces. If it can't be avoided, then applying more membrane liquid to confirm the fabric's shape with the wall.
2. Applying 2-3 layers of the tape for a stronger and more waterproof application. Do not forget to use a waterproofing membrane liquid every after layer.
3. The ATack Waterproofing Membrane Sheet is compatible on all leading waterproofing membrane liquid brands such as RedGard and Laticrete.
Multiple Layer Application
You can also opt applying multiple layers to increase the waterproofing. If you are to do so, applying the layers in varying and perpendicular angles. By creating a criss-cross pattern for 2-3 layers, you can produce a support that is rigid.
User Manual
Gel Ink Pen
Everything you need to know to protect your floors during your next project. Follow these simple steps for best results.
Pro-Tips for Best Results
Grid large rugs.
Tape the perimeter first, then cross the center in a grid to stop bunching in bigger carpets.
Reinforce the trouble spots.
Add extra strips at corners and high-traffic paths — the first places a rug lifts.
Press from the center out.
Pushing outward from the middle clears air pockets and uneven spots as you go.
Let pressure do the work.
Firm, even pressure — by hand, with a book, or with a roller — is what turns a placed strip into a lasting bond.
Cut clean.
Straight cuts from scissors or a utility knife make the liner easier to peel and the final placement easier to line up.
Match tape to floor type.
Reserve this tape for sealed hard floors; skip it on unfinished wood or soft flooring where the bond will not hold as intended.
Safety Guidelines
Ensure the floor is dry
Applying film over a damp or wet floor can trap moisture underneath and create a slip hazard. Confirm the surface is fully dry first.
Mind foot traffic during application
Keep the work area clear of foot traffic while applying the film to avoid slips on the partially-adhered surface.
Storage & Handling
Store rolls flat and dry
Keep unused rolls in a cool, dry place, laid flat, to prevent the adhesive from degrading before your next project.